How with an oil life indicator system determine when it's time to change the oil and Oil Filter on BMW Z4?

Question

Accepted Answer

Some of these vehicles come with oil life indicator system which in form of a light or message on the instrument panel tells you when it is time to change the oil, based on factors that assess the state of the oil for wear. This system generally enables the car to be used for more than 3,000 miles before the oil is changed but constant change is advised for the engines' sake. If the decision is made to go with the convenience of the oil life indicator, do not go over 15,000 miles between changes. These are the examples of the basic types of preventative maintenance since the old oil may cause harm to the engine of the vehicle. Before starting prepare all necessary tools and materials that are going to be needed, and it is also necessary to have rags and newspapers for cleaning stains. Engine oil is easier to drain when it is warm, but do not flush hot engine components. It is customary to wear gloves when handling used oil due to skin adversative effects. touching the base of the car is relatively possible if the car is raised to a correct angle, and it centralizes. Identify where the oil filter housing is found in the car, find a rag and put it around the area to prevent staining and then using a correct tool, you can bet to remove the housing cover. Discard the filter cartridge, take out old O-rings and then, clean the surfaces where O-rings are to be placed. Replace the new O-rings and the new filter cartridge must be put inside the housing and Apply only clean engine oil to the O-rings and the to tighten the cover to the required torque. Beneath the automobile, unscrew the oil filter and oil drain plug, be safe and wear gloves, place the drain pan below the plug. Let the old oil settle down and drain, next, remove the drain plug and gasket and clean them and if necessary replace the gasket. After deflating it again there is the need to re-fit the plug and make sure it is tightened enough. Take off the old oil and the assorted tools that would have been used from under the car and if necessary, drop the car. Take out the dipstick and the oil filler cap, pour the appropriate type and amount of oil into the engine with the help of a funnel so that to avoid spilling of the oil. Switch on the engine, look for any leakages then confirm whether the oil warning lamp off or not. After five to ten minutes shut off the engine and let the oil pan settle down, and then check the level on the dipstick and add oil if necessary, but do not over fill the engine. Assume responsibility for all used oil and filters properly; learn from local sources where one can dispose used oil; and finally used oil should be stored in proper containers before being transported to a disposal center.

Genuine BMW Z4 Oil Filter

15 Oil Filters found

BMW Z4 Oil Filter

BMW Z4 Oil Filter

BMW Z4 Oil Filter

BMW Z4 Oil Filter Element Set

BMW Z4 Oil Filter

BMW Z4 Oil Filter

BMW Z4 Oil Filter Element Set

BMW Z4 SET OIL-FILTER ELEMENT

BMW Z4 Oil Filter Element Set

BMW Z4 OIL FILTER

BMW Z4 Oil Filter Housing

BMW Z4 Oil Filter

BMW Z4 Oil Filter Element Set

BMW Z4 Support With Oil Filter

BMW Z4 Oil Filter Element Set

BMW Z4 Oil Filter

BMW Z4 Oil Filter Parts Questions & Experts Answers

Related BMW Z4 Parts

Browse by Year