BMW 51247016186 Gas Pressurized Spring, Trunk Lid

You can Select Your Vehicle to check if 51247016186 fits your vehicle.

To take off the trunk lid, one needs to open the trunk and then take out the screw that retains the toolbox lid, then take out screws from the toolbox hinge and then finally take out the toolbox that was fixed at the trunk trim panel. After that, it is necessary to lift the center pins and pull out the plastically expanding rivets to remove the trim panel of the trunk lid. Stabilize the trunk lid in the open position to help un-hook the Trunk Lid Lift Supports. Remove the rivets of the number plate light wiring connectors and all the wiring connectors bound to the luggage compartment light switch and the central locking servo if any: Reel a string to the individual ends of the wiring. Pay attention to the correct positioning of a wiring harness, pop sometimes located rubber grommets from the trunk lid part and pull the wiring. After the last piece of wiring is seen, remove the string and keep in place for installation purposes. Mark around the outline of each hinge with a marker pen, and then removing the hinge-retaining bolts, the trunk lid will be easily removed. Check the condition of the hinges and replace when possible as the doors are mounted with bolts. With regard to the new branded configured tailgate, removal and installation of the same are quite complex and it is recommended to ensure those services from the BMW dealer or any qualified technicians. To remove the Trunk Lid Lift Supports, lift the trunk lid or tailgate as required, then use a small flat-bladed screwdriver to prise up the spring clip, then pull the Trunk Lid Lift Support away from its top fixing, and then repeat the process for the lower fixing. When installing the trunk lid, the process should be done in the reverse of the removal procedure and screw the hinges on the made marks. Once installed, tighten the nut which holds the trunk lid and align it properly with other parts of the car; if not properly aligned, just loosen the bolts that hold the part into place. If there are any residues of paint on the hinge region, clean them up with a suitable brush because if they are left to decay, they are likely to cause corrosion. In the same way, installation of the Trunk Lid Lift Supports is the reverse of the removal process with emphasis checked on the fact that the strut is held firmly in its clips.