BMW 62109168170 Instrument Cluster Speedometer

You can Select Your Vehicle to check if 62109168170 fits your vehicle.

To remove the center console, one has to pull the gear shift knob up to release it from the shift lever. Secondly, remove the gear lever surround trim during which it will be necessary to indicate the positions of Fixings for wiring connectors. Go for the removal of the steering column combination switch and boththe glove boxes. Then take out the panel positioned above the pedals: three screws, expanding plastic rivet, and plastic nut; disconnect the OBD socket and light wiring connectors. Detach the finish moulding strips on both sides of the shell of the instrument panel with a wooden or plastic scraper, to protect the face of the panel by placing cardboard on it. Subsequent to that, disconnect both of the instrument cluster assembly harness connectors then pull it out from the dashoard then, remove the heater control storage compartment lid to pull out the heater control from the dashboard. Six screws hold the storage compartment carrier - unscrew them with care for their positions, and if there are wired connectors on the carrier, this is the moment to disconnect them. Subsequently, remove both A-pillar trims, the light switch, the heaters control panel, the audio unit and the passenger airbag unit. On the passenger side there is a screw hidden in trim recess which has to be unscrewed, on the driver side than there is a air vent that can be pulled out by removing the retainers screws. Pop the hood and look at the far right side of the instrument panel, you will see a screw or an expanding plastic rivet, unscrew or pull it out. Disconnect the nut holding the in strawtery panel to the back of the gear lever and push back the front seats to be in a position to undo the instrument panel mounting nuts. With help, remove the instrument panel from the firewall, tearing off any center air vent cable, as well as other wiring connectors, if necessary. For installation reverse all above steps done while removing and in this way confirm that the instrument panel has to be fixed in right manner and all the wiring of control panel has to be fixed in right manner. Fit the remains of the instrument panel back into its place and tighten bolts, screws etc, replace the batteries and switch on all the electrical appliances and controls for confirmation that they are working as they should.

Reconnect the battery and check the operation of the cluster warning lights to ensure they are functioning correctly.