BMW 33107566175 Rear Axle Drive Differential

You can Select Your Vehicle to check if 33107566175 fits your vehicle.

New nuts for the driveshaft rear coupling and new bolts for the driveaxle retaining will be required during installation. Removal: Block the front wheels. Raise the rear of the vehicle and securely support it with jackstands. Remove both rear wheels. Use paint or a marking pen to make alignment marks between the driveshaft and the rear differential flange. Unscrew the bolts/nuts that secure the driveshaft to the rear differential and discard them; new ones must be used during installation. Remove the driveshaft. Disconnect the vent hose from the differential. On E-series chassis models, remove the driveaxles. On F-series chassis models, the driveaxles must be removed once the rear differential is partially lowered. Do not allow the driveshaft to hang under its own weight as the CV joint may be damaged. Discard the bolts; new ones should be used during installation. Remove the nuts/bolts and the heat shield panel from the left-hand end of the tension strut beneath the differential input-shaft flange. Move a floor jack and a block of wood into position and raise it so that it supports the weight of the differential. Making sure the differential is safely supported, loosen and remove the bolts securing the front of the unit to the subframe and the single bolt securing the rear of the differential to the subframe. Carefully lower the rear differential out of position and remove it from underneath the vehicle. Examine the differential mounts for signs of wear or damage and replace them if necessary. Installation: Raise the differential into position and engage it with the driveshaft rear joint, making sure the marks made prior to removal are correctly aligned. Insert the differential front mounting bolts, then the rear bolt. Tighten the front differential mounting bolts to the specified torque setting, followed by the rear bolt. Install the new driveshaft joint bolts/nuts and tighten them to the specified torque. Install the new driveshaft joint retaining bolts and plates and tighten them to the specified torque. Refill/top-off the rear differential with oil.

Disconnect the negative battery cable, block the rear wheels, and raise the front of the vehicle and securely support it on jackstands.