BMW 13621709966 Temperature Sensor

You can Select Your Vehicle to check if 13621709966 fits your vehicle.

To remove and install the ECT sensor, follow the specific instructions for your engine model. It is important to allow the engine to cool before removing the sensor to avoid burns. Unplug the electrical connector, use a 12 point 22mm thin wall deep well socket to remove the sensor by turning it counterclockwise. Remove the sensor along with its sealing washer. When installing the sensor, use a new sealing washer and tighten it to 10 ft. lbs. (14 Nm).

Prior to 1996, the fuel injection temperature sensor and coolant gauge temperature sensor were separate units. In 1996 and later models, these sensors were combined into one unit with four wires and should not be substituted for the previous two-wire version.