BMW 11221709032 Flywheel

You can Select Your Vehicle to check if 11221709032 fits your vehicle.

Remove the transmission. Remove the clutch cover and plate on manual transmission equipped vehicles. Install a flywheel lock to hold the flywheel stationary. Remove the bolts and pull the flywheel off. To install, clean the mounting area of the crankshaft. Check the condition of the rear main seal and replace if necessary. Clean out the bolt holes. Use only new bolts when installing the flywheel. The bolts are not designed to be used more than once. Install the flywheel, and using new fasteners coated with a suitable locking agent, tighten and torque in a three step crisscross pattern as follows: S14/M20 M12 fasteners: 82-94 ft. lbs.(113-130 Nm), M42/M44 micro encapsulated fasteners: 88.5 ft. lbs.(120 Nm), all engines with automatic transmission, micro-encapsulated fasteners: 88.5 ft. lbs. (120 Nm), all others. micro-encapsulated fasteners: 77.4 ft. lbs. (105 Nm). The balance of assembly is the reverse of the removal procedure.

To check the viscous coupling, place a protective cloth over the pressure plate and rotate it in a clockwise direction until the flywheel barely begins to move. Match mark the pressure plate and the outer body of the flywheel. Then, rotate the pressure plate in a counterclockwise direction until the flywheel barely begins to move and match mark it again. The pressure plate should be able to be moved between the two match marks without excessive force or looseness.